Recent content by bowT3ch

Yep, that's the part # that matches the Delphi SL10064. Yes, it is the revised version with the wrapped spring (good description). thanks for everyone's help and quick responses!! I'll change it out tomorrow.

Sorry, yeah the CPAS. Ok, so it's probably failing but has yet to show any symptoms. I cleaned the connector and put it back in (for now) since I needed to drive it. She drives great. Is a Delphi considered OEM? Should I use it to replace the other one?

at 170,000 miles, I decided to pull my CPA just to clean it. She runs well, but just decided to do a little preventive maintenance. I found oil in the plug harness. The CPA is very clean. I bought a Delphi SL10064 ('03 - 4.2) just in case old one was bad. after reading some here I have 2...

Just a heads up in the service manuals... for Torque specs, they will at times switch to IN LBS instead of FT LBS. It's a big difference and you realize is fast when you torque it down, but just thought I'd throw it out there. (I apologize if it's already posted)

I think the frame moved when I jacked it a bit higher. The crossmember is in great condition.

After thinking about it, I went back to my repair records and found receipts for alignments for the last 4 yrs. Not a single one was within caster specs. How the heck did I miss that? This alignment is the closest to being within specs. The alignments have been done by different shops. For...

No special mods. When I went to put the crossmember back on, the holes didn't line up on the same side that is out of caster spec. I was able to move the holes over about 1/2" to re-align with crossmember. That's the only issue I had. I realize the crossmember helps keep it aligned. I...

I've been reading advice on GMTNation for quite a while, but this is my first post. I appreciate all the advice. This site has saved me a ton of money and I really enjoy reading the posts. So I replaced my steering rack on my 2003 TB EXT LT. It went really smooth. I got it aligned. Camber...