Recent content by jmonica

  1. jmonica

    Temp loss of throttle when cold

    So yes I still have the EV fan. The secondary air injection system is whacked. I get the jet engine sound on startup. It runs for about 10 seconds and then it winds down. So I'm guessing it's related to that. You had told me a long time ago that this can be disabled with a tune, but I don't...
  2. jmonica

    Temp loss of throttle when cold

    I do not see the Reduced Engine Power indicator appear when this happens. Thank You!
  3. jmonica

    Temp loss of throttle when cold

    Hi. When I start my car in the morning, I drive about 30 secs and then the throttle goes dead neaa asking I depress the pedal and it doesn't react. It feels like the car is about to die but it doesn't. After about ten seconds, it starts running normal and I continue on my way. It's been...
  4. jmonica

    Handbrake release without a handle? Please help?

    Please disregard. I just pulled the shoes out of the hats. Thanks
  5. jmonica

    Handbrake release without a handle? Please help?

    Hey Guys, My rear dust shields (backing plates) are rusted away. The drivers side is scraping on the rotor. I am about to break off the pieces that are rubbing the rotor, but I noticed the rear wheel, rotor etc are very hot. I just came back from a 5 minute drive to the parts store. It...
  6. jmonica

    U1016, u1026, u1064

    Thanks MRRSM. I watched the video, twice. I'm going to start trying to isolate the problem. I'm doubtful I will figure it out, but I don't have any other options at this point. I appreciate your help very much. Enjoy your weekend!
  7. jmonica

    U1016, u1026, u1064

    Hello. I've started having yet another intermittent problem. Car starts fine, after a few minutes I depress the accelerator and the engine won't rev. After 15-45 seconds it goes back to normal and runs ok. I currently have codes U1016, u1026, u1064 as well as a p0449 which I don't think is...
  8. jmonica

    Car won’t start, doors won’t lock or unlock from inside or fob

    Yep. I can concur with this. I had a fuse that tested fine in the fuse panel /block. It looked fine (Not blown or burnt out) when removed, but one of the "legs" was broken in a place that you couldn't see the break, so it was causing an intermittent problem. The lesson I learned was that if...
  9. jmonica

    NEED HELP Intermittent Dash Lights/Door Locks Cycling/Radio Out ... Ground?

    Now this is a helpful post!!! Thank You for taking the time MRRSM!
  10. jmonica

    All dash lights on

    Thank You. I'm going to do a thorough check of all of the grounds and have the battery tested.
  11. jmonica

    All dash lights on

    Thanks Moose. That's exactly what I did to reset everything, because I do that to get rid of the Stabilitrac light as well. I've replaced the SWPS twice and the light went away for a month or two both times, but came back. I'm not buying a third one. I can't help but feel there's a ground...
  12. jmonica

    All dash lights on

    On my way to work today, out of the blue, every light on my dashboard lit up. I was just cruising along at about 60mph. Like when you turn the key on before you start it. CEL, Traction control etc.. every warning light. Also, all if my gauges went dead. At the same time, my radio shut...
  13. jmonica

    Electrical Ground locations

    Hello. I'm not sure if this will help anyone. I got tired of scrolling through the entire electrical manual to figure out which page each Ground Location diagram was on, so I created this for myself. You can click the Figure number on the top table to take you directly to the corresponding...
  14. jmonica

    O2 Sensor Recommendation please?

    Thank You Mike. I went with your recommendation and purchased the NKT (21023) for the downstream sensor. I honestly wouldn't have considered that brand until I read your post and Rock Auto lists the part as an "Actual OE Part", so you appear to be spot on. Anyway Thank You Sir!
  15. jmonica

    O2 Sensor Recommendation please?

    Thank You for your reply and help. I apologize of my post was too wordy.

Forum Statistics

Threads
24,251
Posts
648,421
Members
20,690
Latest member
SAM1265

Members Online