Recent content by mika

Well thank you very much for the full detail of the A to Z on the subject. I will do the engine flush as you mentioned, I did change the cam actuator, also the cam sensor, fresh oil, cleaned TB and did the sea foam through brake booster, put some in the oil and in the gas tank, but didn’t do an...

Code P1345 Good morning everyone, been fighting with this code for some time now, I have replaced the cam position sensor as well as the actuator sensor, need an e-test and can’t do it with this darn light on. Has anyone else had this problem? Someone mentioned a phaser ( cam gear ) are these a...

Could be just the selector switch its self, has it ever change to 4hi with you touching the switch? or when you go to select 4hi or low it just flashes until the light does out? if so the selector switch might be just it. Try turning the switch (with the ignition switch off) from left to right...

Hey everyone, nice hot summer no? I encountered a problem last with the cruise controle, it will not come on, I believe I checked the right fuse, #31 under the back seat, a 3 amp.. Is there something else I should be looking for? thanks for the help.

did you check the upper balljoints, also the top plates.

Don't know what to call it but it's what holds the third brake light . the whole plastic piece that holds on by 4 bolts. Well mine broke off, the inner part that bolts right above the hinges broke off and busted the left side ancore too. Iwas in the minst of gluing it back up, decided to make...

Well all is good, purs like a kitten. Fells good when it don't cost much more than labor, my own labor that is. Thanks guys

All good thoughts and prayers for you, my mom has beat it 2 times in the past 4 years. colline and lung and is free of it now. Stay strong friend, :thumbsup:

I guess I should red before I ask certain questions.... Thanks Roadie. So dry cracked rubber seals are not totally to blame?

Good morning everyone, now that I've been placed back on track on which cylinder is #4, I took it off and yup..... it was full of water... But why? I'm no stranger to engines and backyard mecanics but Ive never seen water not just moisture but water, a good ounce or so. What would cause this? I...

Thanks, I'll take a look tomorrow.

As Roadie said if any water or oil in any well I would get a code, got home and had a code.. P0304.. cylinder #4 missfire, so pop off the coil pack and found moisture around the metal brass colored like ring if you want to call it that, so I air hosed it and got more wet stuff off of it. It was...

Nope no codes, ac dosen't work, and it's only when I am not driving only when I am stopped, in park or drive makes no differance. I even opened the hood to watch the engine, it gives a little shake then stops. It's also not consistant. Don't get me wrong, I am not ruleing out the mounts.

Dose no replys mean that all it takes is a minor tune up?