Talking about the trim on the floor under the doors and the piller between the 2 doors and behind the the 2 rear doors removing it all on both sides to run new wiring. thanks. Want to run rca cables and speakers down 1 side and power down the other.
Quick ? roadie or for some else who may know removing the trim from dash back is it only plastic clips holding it in place or is it screwed in in certain places . thanks been searching and all i can find is about the dash.
i know the fpr can cause it but the fpr is in the pump assembly and that was replaced the summer and had the fuel pressure test couple months back and it was withing specs if i remember correctly it was @ 53 psi so that's y i"m thinking injectors and the temp is a touch low but from what i read...
yes the temp needle stays straight up and down and scan tool reads between 187 and 194 mainly around 190
and were it's a cold start wouldn't think a bad ts would cause the extra fuel on startup
think i'm going to look into getting an injector balance test done from what i can tell sure seems to me like an injector leaking down over nite. after using the injector cleaner a few time not so much of fuel smell on cold starts but black smoke now.