Recent content by kctrailblazer

Thank you so much for the info. Ordering the new one from rock auto when i get home.

I guess let me order the ac/delco one. Has anyone ever found a problem in the harness from the bcm to the fuse block? thanks for the info

Yes, I replaced it with a Duralast , it worked then stopped. I also notice that when I use my key fob the headlights no longer come on. something is blowing them and at 27 dollars a pop i'm afraid of blowing another one.

could use some help. my hdm went so I replaced it and it worked fine for a few hours and then nothing, I tested the hdm in the fuse block, I have ground on the 6 pin, power on the 2 pin, and when I hook my test light to the positive battery terminal and probe a test lead from pin 5 it lights...

thank you so much

so does anyone know the gm part number for the three bolts that hold the bracket in place? One of the bolts is warn pretty bad and if I put 192 ft lbs on it will probably snap.

thank you so much..i will let you know

I haven't used a torque wrench yet. do you by any chance know what the torque specs are?

that particular noise didn't happen until I replaced the lower control arm.. so I was worried it was that but everything is tight.

I only did the outer.

so I really need help here. I have replaced the upper and lower control arms, struts w/coil springs ,sway bar bushings ,sway bar end links, tie rod ends and hubs and now sometimes there is a almost bang or creak that happens. almost sounds like the lower control arm is maybe shifting where it...

:biggrin:i figured it out..thanks for the info:thumbsup:

thank you for your help..what would you use to clean the block..i used a brass brush and it looked pretty clean.as far as torque specs 89 inch pounds what does the (10Nm) stand for?

hello everyone, I know I seen a post somewhere about how tight to make the thermostat bolts but after an hour of looking can't seem to find it.i changed my thermostat about 2 weeks ago and didn't have any leaks but now it seems to be leaking and I don't want to over tighten it and snap a...

I have 94k miles on my 03 TB and i was wondering what type of oil i should use?:undecided: