Recent content by szieziel

If I remember correctly, the boot is not blue... there was a blue plastic cover that fit over it for shipping

I ordered the raybestos about a year ago, they had sealed ball joints and were the complete assembly - quality wise they compare favorably to the factory units

I could see this as a park rental in places around salt lake and vegas TopGear had a mobility scooter off road challenge http://www.youtube.com/watch?v=ejkmQffNYjk

the p/n's are for retrofit kits that are normally dealer installed, but should still come with instructions I believe the reason for the different numbers is for engine specific hoses included in the kit - the pump and wiring should be the same from the diagrams online - it looks like the 2006...

I don't have one, but from what i have seen, the rear heater core 'booster' is an aux electric water pump to circulate the coolant to the rear core faster - there is a lot of plumbing to lose heat along the way. it gets installed by the heater bypass valve, passenger side firewall, and is...

I use the Torque android app to check the percent on my '03. PID:22119f equation:A/2.55

My drivers window had been doing this when wet, so I took the door panel and splash shield off, sprayed and wiped down the window guide at the very back of the door with silicon spray... probably not the best choice, but what I had - I think I will do it again with dry teflon spray So far no...

I drive about 90% city and my running average is 12.9mpg actual is about 11city 19hwy (4x4 ext) in the past 15 months: high of 21 - low of 9, the high one was all highway from Philly to Durham , some of the lows were either extended periods of idling, bad o2 sensor or other maintenance issues

the s2 is a WiMax phone, which columbus seems to have good coverage with - and your area is not on the list for LTE yet ( that will change in 2014 when they start converting their 800mhz spectrum from iDen to LTE band 26 ) if the sprint network is good for you and you don't go into roaming...

not exactly what you were looking for, but Plaen wrote an article on routing the headlight wiring to the fog lamps, then using the headlamp on signal wire back at the switch as the switched negative for the HID relay harness.... result fogs as DRLs, auto HIDs and quad beam...

re-post from os - the link i posted earlier needs mod approval credit: silverunicorn as you can see some of the dimensions are missing and no angles listed, he listed the stock as aluminium .100" thickness

there is a post on the os by silverunicorn that has most of the information to fabricate them here: OEM fog light install......need brackets - Page 2 - Chevy TrailBlazer, TrailBlazer SS and GMC Envoy Forum

it's kind of hidden behind the tire