VCX nano tis2000 setup?

[Thchevelle70]

I have just received a vcx nano and it came with a windows 7 vm and gds2 setup I need tis2000 for the sps mode I also have a windows xp vm so the problem is on 7 tis will install but hangs up and freezes after clicking sps and on xp I can get to the setup of sps but it can't communicate with the vcx I believe a driver issue I'm not sure how to configure it any help appreciated I've read many forums tried different install procedures any direction appreciated I'm just trying to reprogram the rke module

 

[mrrsm]

Please View, Download and SLO-MO this VCX NANO Software Installation Guide Video ...and see if there are any differences in the installation steps and procedures that the VOP followed that differed from your own. Also, look to see whether or not this VOP (Video Original Poster) was using an EARLIER or a LATER version of the Installation Software, Ancillary Applications and Actual or Virtual Drivers, as well:

 

[Thchevelle70]

I need tis2000 for the sps mode I've done all that plus installed tis with the crack the disc the vcx came with has those same files but I sourced tis2000 off the interwebs not sure if the tech2win driver is the same but the pop up to select the mdi and usb interface never pops up so I used xp and it does but says it can't communicate with the device still and the vcx device has a newer firmware idk if that matters

 

[Mooseman]

A quick Google search found this:

VXDIAG VCX NANO GM works good with TIS2000 & Tech2Win | Chinacardiags.com Official Blog

So far, i have good success with Allscanner VXDIAG VCX NANO GM + TECH2WIN. And now, i can make it work well with SPS, TIS2000 also. VXDIAG VCX NANO GM +

blog.chinacardiags.com

Says Tis2000 won't work with the crack in the VM that it came with.

 

[Thchevelle70]

Ok so I ran another vm of 32bit windows xp to see if that would fix it is it not compatible with vm maybe

 

[Mramses]

Ok so I ran another vm of 32bit windows xp to see if that would fix it is it not compatible with vm maybe

hello friend could you solve the connection of vxdiag with tis2000? Thank you

 

[LikeEnvoy]

I just got past the sps hang up by following a tip on another site. When installing the dongle crack, I had an error while running the driver registry tool in the dongle crack folder. Every time I selected SPS it hung for ages then said access to the SPS server was denied.
Following the tip, I opened TIS2000 and selected configuration from the menus.
In the list of drivers I selected and deleted the dongle driver. Closed the window and then tried SPS. Now it starts SPS ok!
However, my next problem is trying to connect to an IPC on my bench. I have a VCX FD connected from laptop to IPC (by my mini bench-harness, with Diagnostic connector, power supply connection and serial data wire from DLC to IPC).
I go through the SPS selections for GMC Envoy, 2007 etc. but when I try to connect, it cannot connect to the IPC.
I am stuck at this point.

 

[Mooseman]

Does it work with any other modules? Can you use it in the vehicle?