Matt's latest activity
-
New OE Oil pressure sensor to replace the one that is leaking. -
Well, with respect to the ignition switch, the verdict is in--I hope. The photo below shows the switch I just removed on the left, the Dorman version, and on the right is the one I had removed a...
-
Matt reacted to Mooseman's post in the thread What did you do to your GMT today? [Part II] with
Sad.
This morning, at -8c (where is spring???), leaving for work, started the TB and immediately heard a gurgling noise and saw fluid gushing out under the truck. Shut it off immediately. Checked and... -
When that thing breaks loose, stand back/by for a "shot" sound and maybe something flying. I still say heat or remove the entire assembly and take to a press.
-
Round 1..... no dice. Used the puller and the 8 pound. Hopefull it might have budged, just a bit.... almost broke the windshield as a small impact socket I put on the forcing screw went...
-
Matt reacted to azswiss's post in the thread What did you do to your GMT today? [Part II] with
Like.
Pulled the connector on the oil pressure sensor and, sure enough, it is oil wet so the sensor is leaking. This may also help explain the minor oil leak I have been trying to track down. -
Matt reacted to azswiss's post in the thread What did you do to your GMT today? [Part II] with Like.
What I will be doing to my GMT this weekend . . . looking into a "Low Oil Pressure" warning I got last night. Pulled into a parking lot immediately and shut off the engine. Checked the dipstick...
-
Its still in the shop sitting (lucky to have shop room and a surplus of vehicles) it was soaked with pb blaster. I am thinking of using some version of a large puller, whether a 3 jaw or even a...
-
Matt reacted to krunal88's post in the thread What did you do to your GMT today? [Part II] with Like.
Put some grease on the slip yoke today on the TB. Had the occasional thud/clunk when stopping and take off. Let’s see how it goes.
-
Helping wife to prepping to make Easter dish and dessert for family gathering on Sunday. Later picking up daughter's ride from shop and swapping rides at her work so I can get my 05' SWB TB back...
-
@movietvet there is no c clip from what I can see. The inner tripot came off the differential stub shaft easy enough but the rest had been a nightmare. so, an all night soak, cycled more heat...
-
I finished up the brakes on our new to us 2020 5th gen Ram 1500. I bled 1.5 litres of brake fluid through it, greased the slide pins, popped the rotors, antiseize on the hubs and a little grease...
-
Matt reacted to movietvet's post in the thread What did you do to your GMT today? [Part II] with Like.
Received a new lumbar adjustment knob for the driver's seat. My girl's 2002 TB with 78k miles. Received box, cut open, walked out to TB, unlocked door and knelt down and pushed on the knob after...
-
Matt reacted to Mooseman's post in the thread What did you do to your GMT today? [Part II] with Like.
Friday I did the cooler line. It was the part that holds the little clip that holds the lines together that corroded. I just cut off the joint and patched it with hose and clips. I couldn't put...
-
Matt reacted to Mooseman's post in the thread What did you do to your GMT today? [Part II] with Sad.
Guess what I'm doing this weekend? And the funny thing is, it happened near the same spot that it last happened with my '02 back in 2014. This time it's likely a rusted out line. Just waiting...
-
My TB was due for an oil change so with the recent discussions about Valvoline R&P I decided to go with that. I had also been considering for some time doing an ACDelco TEC as well and had bought...
